ZyXEL Communications PLA-470 V2 - V3.0.5 Instalační příručka stáhnout pdf (Strana 246)

The WinPCap tool used for managing inputs/outputs on the network interface

card must be installed beforehand. This tool is generally pre-installed by the PLC

configuration tools. If not, it can be downloaded at the following address:

http://www.winpcap.org/install/bin/WinPcap_3_1.exe.

Once the WinPCap tool is downloaded and installed, just proceed in the follow-

ing way to install the ConfigurationPrioritéCPL tool:

•

Download the ConfigurationPrioritéCPL.zip file, then decompress it in a local

directory.

•

Run the tool by double-clicking on the ConfigurationPrioritéCPL.exe file.

Once the tool has been launched, a DOS window prompts you to choose one of

the priorities, 0(CA0), 1(CA1), 2(CA2) or 3(CA3), as illustrated by Figure 10.9.

Once the priority is chosen, the tool prompts you to choose the Ethernet net-

work interface card of the PC locally connected to the PLC device. The IP address

information is used for recognizing the correct network interface card. In the case of

Figure 10.10, the board connected to the PLC gateway is board 3 whose IP address

is 192.168.0.10.

Configuring Security Parameters 227

Table 10.3 Data Traffic Priority Levels for the PLC Gateway

PRIORITY FOR DATA TRAFFIC HomePlug 1.0 AND TURBO PRIORITY

0 CA0 Low priority

2 CA1

4 CA2 High priority

6 CA3

7 (highest priority level)

Figure 10.9 Launching the PLC priority configuration tool

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 348 349

Žádné komentáře

ZyXEL Communications PLA-470 V2 - V3.0.5 Instalační příručka Strana 246