ZyXEL Communications PLA-470 V2 - V3.0.5 Instalační příručka Strana 120

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 349
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 119
Protocol version. Defines the value of the protocol used. This value is reserved
and will only be used during a standard evolution.
Bridged. Indicates whether the PLC station transmitting the data is in bridge
mode and has the potential for relaying the frames to other network stations.
MCF (multicast flag). Indicates whether the frames are sent in multicast or
broadcast mode by setting this value to 0b1.
CAP (channel access priority). Reuses the priority level of the source station in
comparison with the other stations of the PLC network.
Segment length. Used to find out the data length of the transmitted segment.
LSF (last flag segment). Used to find out, if the value is set to 0b1, that this
segment is the last BS segment.
Segment number. Indicates the fragmentation and reassembly order for the
various BS segments.
Segment sequence number. This number, set to 0, is assigned to each frame
and incremented by 1 steps for all the other transmitted frames. If a frame is
fragmented, all the segments of this frame have the same sequence number.
Address Fields
In HomePlug, all the address fields have a 6-byte length and the same format as the
addresses defined in the IEEE 802.3 standard.
MAC Layer Frames 101
Figure 5.16 HomePlug 1.0 MAC frame header
Zobrazit stránku 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 348 349

Komentáře k této Příručce

Žádné komentáře