ZyXEL Communications GS3700 Series Uživatelská příručka Strana 336

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 416
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 335
Chapter 41 Maintenance
GS3700/XGS3700 Series User’s Guide
336
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
41.8.2 FTP Command Line Procedure
1 Launch the FTP client on your computer.
2 Enter open, followed by a space and the IP address of your Switch.
3 Press [ENTER] when prompted for a username (the default is “admin”).
4 Enter your password as requested (the default is “1234”).
5 Enter bin to set transfer mode to binary.
6 Use put to transfer files from the computer to the Switch, for example, put firmware.bin ras-0
transfers the firmware on your computer (firmware.bin) to the Switch and renames it to “ras-0”.
Similarly, put config.cfg config transfers the configuration file on your computer (config.cfg) to
the Switch and renames it to “config”. Likewise get config config.cfg transfers the configuration
file on the Switch to your computer and renames it to “config.cfg”. See Table 168 on page 335 for
more information on filename conventions.
7 Enter quit to exit the ftp prompt.
41.8.3 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP clients.
41.8.4 FTP Restrictions
FTP will not work when:
FTP service is disabled in the Service Access Control screen.
The IP address(es) in the Remote Management screen does not match the client IP address. If
it does not match, the Switch will disconnect the FTP session immediately.
Table 169 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode. Configuration
and firmware files should be transferred in binary mode.
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).
Zobrazit stránku 335
1 2 ... 331 332 333 334 335 336 337 338 339 340 341 ... 415 416

Komentáře k této Příručce

Žádné komentáře