ZyXEL Communications GS3700 Series Uživatelská příručka stáhnout pdf (Strana 317)

100

101

Chapter 38 VRRP

GS3700/XGS3700 Series User’s Guide

317

38.3.3 Configuring VRRP Parameters

After you set up an IP interface, configure the VRRP parameters in the VRRP Configuration

screen.

Figure 203 IP Application > VRRP Configuration: VRRP Parameters

The following table describes the labels in this screen.

Table 162 IP Application > VRRP Configuration: VRRP Parameters

LABEL DESCRIPTION

Active Select this option to enable this VRRP entry.

Name Enter a descriptive name (up to 32 printable ASCII characters) for identification

purposes.

Network Select an IP domain to which this VRRP entry applies.

Virtual Router ID Select a virtual router number (1 to 7) for which this VRRP entry is created.

You can configure up to seven virtual routers for one network.

Interval

Specify the number of seconds between Hello message transmissions. The default is

Preempt Mode Select this option to activate preempt mode.

Priority Enter a number (between 1 and 254) to set the priority level. The bigger the number,

the higher the priority.

This field is 100 by default.

Uplink Gateway Enter the IP address of the uplink gateway in dotted decimal notation.

The Switch checks the link to the uplink gateway.

Response Ping Select this option to have the Switch respond to a ping that is sent to the virtual IP

address.

Primary Virtual IP Enter the IP address of the primary virtual router in dotted decimal notation.

Secondary Virtual IP This field is optional. Enter the IP address of a secondary virtual router in dotted

decimal notation. This field is ignored when you enter 0.0.0.0.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 415 416

Komentáře k této Příručce

Žádné komentáře

ZyXEL Communications GS3700 Series Uživatelská příručka Strana 317

Komentáře k této Příručce