ZyXEL Communications GS3700 Series Uživatelská příručka stáhnout pdf (Strana 283)

Chapter 34 Static Route

GS3700/XGS3700 Series User’s Guide

283

Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses hop

count as the measurement of cost, with a minimum of 1 for directly connected networks.

Enter a number that approximates the cost for this link. The number need not be precise,

but it must be between 1 and 15. In practice, 2 or 3 is usually a good number.

Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top navigation

panel to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Clear Click Clear to set the above fields back to the factory defaults.

Index This field displays the index number of the route. Click a number to edit the static route

entry.

Active This field displays Yes when the static route is activated and NO when it is deactivated.

Name This field displays the descriptive name for this route. This is for identification purposes

only.

Destination

Address

This field displays the IP network address of the final destination.

Subnet Mask This field displays the subnet mask for this destination.

Gateway

Address

This field displays the IP address of the gateway. The gateway is the immediate neighbor of

your Switch that will forward the packet to the destination.

Metric This field displays the cost of transmission for routing purposes.

Delete Click Delete to remove the selected entry from the summary table.

Cancel Click Cancel to clear the Delete check boxes.

Table 140 IP Application > Static Routing > IPv4 Static Route (continued)

LABEL DESCRIPTION

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 415 416

Žádné komentáře

ZyXEL Communications GS3700 Series Uživatelská příručka Strana 283