Zyxel-communications 5 Series Uživatelský manuál stáhnout pdf (Strana 541)

100

101

ZyWALL 5/35/70 Series User’s Guide

Chapter 31 Maintenance 541

Figure 293 MAINTENANCE > Device Mode (Bridge Mode)

The following table describes the labels in this screen.

Table 194 MAINTENANCE > Device Mode (Bridge Mode)

LABEL DESCRIPTION

Current Device

Mode

Device Mode This displays whether the ZyWALL is functioning as a router or a bridge.

Device Mode Setup

Router Select this radio button and click Apply to set the ZyWALL to router mode.

LAN Interface IP

Address

Enter the IP address of your ZyWALL’ s LAN port in dotted decimal notation.

192.168.1.1 is the factory default.

LAN Interface

Subnet Mask

Enter the IP subnet mask of the ZyWALL’s LAN port.

DHCP DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows

individual clients (computers) to obtain TCP/IP configuration at startup from a

server. Unless you are instructed by your ISP, leave the DHCP check box

selected. Clear it to stop the ZyWALL from acting as a DHCP server. When

configured as a server, the ZyWALL provides TCP/IP configuration for the clients.

If not, DHCP service is disabled and you must have another DHCP server on

your LAN, or else the computers must be manually configured. When set as a

server, fill in the rest of the DHCP setup fields.

IP Pool Starting

Address

This field specifies the first of the contiguous addresses in the IP address pool.

Pool Size This field specifies the size, or count of the IP address pool.

Bridge When the ZyWALL is in bridge mode, there is no need to select or clear this radio

button.

IP Address Click Bridge to go to the Bridge screen where you can view and/or change the

bridge settings.

1 2 ... 536 537 538 539 540 541 542 543 544 545 546 ... 834 835

Komentáře k této Příručce

Žádné komentáře

Zyxel-communications 5 Series Uživatelský manuál Strana 541

Komentáře k této Příručce

Související produkty a manuály pro Hardware Zyxel-communications 5 Series