ZyXEL Communications ZYWALL 70 - V4.04 Uživatelská příručka stáhnout pdf (Strana 76)

5. [ENHANCEMENT]

Add a CI command to turn on or off the LDAP packet parsing in NAT module.

Usage: "ip nat service ldap [on|off]"

6. [ENHANCEMENT]

Add ALG type on policy route.

7. [BUG FIX]

Symptom: ZyWALL WAN fixed 100/full negotiation fail against cisco 3550/2900.

Condition:

(1) Configure cisco 3550/2900 port to fixed 100/full.

(2) Configure ZyWALL WAN to fixed 100/full.

(3) ZyWALL WAN can not sync up; remain down.

8. [BUG FIX]

Symptom: The DHCP table shows incorrect information.

Condition:

(1) Set the ZyWALL's DHCP IP Pool Starting Address is 192.168.102.146.

(2) Add a DHCP static IP 192.168.102.22 for a PC on the LAN.

(3) Add another PC on the LAN but this PC doesn't have a corresponding DHCP

static IP rule, and then it gets 192.168.102.146 from the ZyWALL.

(4) Go to eWC>Home>DHCP Table, the ZyWALL doesn't show 192.168.102.146,

but show 192.168.103.157.

9. [BUG FIX]

Symptom: The packet will be dropped if the device does not have the ARP entry of

the receiver of this packet.

Condition:

(1) Clear ARP table by "CI>ip arp flush".

(2) Send a ping to 168.95.1.1, but the PC will not get a response in the first ICMP

Echo Request.

(3) After the first ping, the rest of pings can get responses.

10. [BUG FIX]

Symptom: PPTP can not pass through ZyWALL from time to time.

Condition:

Topology:

PPTP server --LAN ZYWALL WAN 1--PPPoE—internet WAN 2--PPPoE--internet

(1) Choose Active/Active mode in WAN setting.

(2) Build PPPoE connection both on WAN1 and WAN2

(3) Set Port forwarding 1723 to LAN PPTP server both on WAN1 and WAN2

(4) PPTP client builds connection, and disconnect it through WAN1; then PPTP

client can not builds PPTP connection through WAN2.

11. [BUG FIX]

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 111 112

Žádné komentáře

ZyXEL Communications ZYWALL 70 - V4.04 Uživatelská příručka Strana 76