ZyXEL Communications 2002 Series Uživatelská příručka stáhnout pdf (Strana 56)

VES-1000 Series Ethernet Switch

5-4 Port Setup

Table 5-2VDSL Port Setup

FIELD DESCRIPTION EXAMPLE

Edit Spanning

Tree Protocol

Setup

Press [SPACE BAR] once to select Yes and then press [ENTER] to go to

Menu 6.1 - Port Spanning Tree Protocol Setup. You must enable STP

on the switch (in menu 2) before you configure it on a port(s). Note that

you very rarely need to enable STP on VDSL ports since the VDSL ports

are directly connected to the users.

Edit VLAN Setup You only see this field if you’ve selected 802.1Q VLAN Type in menu 2.

Press [SPACE BAR] once to select Yes and then press [ENTER] to open

Menu 6.1.3 — Port VLAN Setup.

Default Port

Priority

The Default Port Priority value is added to incoming frames without a

(802.1p) priority tag. The default is 0. Use this field to define the default

priority of each port.

Limiting number of

MAC address

Use this field to limit the number of (dynamic) MAC addresses that may be

learned on a VDSL port. For example, if you set this to “5” on port 2, then

only the devices with these five learned MAC addresses may acess port 2

at any one time. A sixth device would have to wait until one of the five

learned Mac addresses aged out. MAC address aging out time can be set

in menu 2. The valid range is from 0 to 254.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your

configuration, or press [ESC] at any time to cancel.

5.1.4 Ethernet Port Setup

Ethernet port connections can be half duplex or full duplex. The Ethernet port must use the same speed / duplex

mode setting as the peer Ethernet port in order to connect.

Please refer to section 2.4.3 for Ethernet port default settings and section 4.2.1 for information on port trunking.

Select an Ethernet port and then press [ENTER] to go to the Ethernet port setup menu.

Figure 5-3 Menu 6.13 – Ethernet Port Setup

The Menu 6.13

– VDSL Port Setup fields are explained in the next table.

Menu 6.13 – Ethernet Port Setup

User Name = Uplink1

Active = Yes

Type = ETHERNET (r.o)

Speed = Auto

Duplex = Auto

Flow Control = Yes

Edit Filter= No

Edit Spanning Tree Protocol Setup= No

Edit VLAN Setup= No

Default Port Priority= 0

Press Enter to Confirm or ESC to Cancel:

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 160 161

Komentáře k této Příručce

Žádné komentáře

ZyXEL Communications 2002 Series Uživatelská příručka Strana 56

Komentáře k této Příručce

Související produkty a manuály pro Sítě ZyXEL Communications 2002 Series