Zyxel-communications Internet Security Gateway ZyWALL 2 Series Uživatelský manuál stáhnout pdf (Strana 437)

100

101

ZyWALL 2 Series User’s Guide

Filter Configuration 30-1

Chapter 30

Filter Configuration

This chapter shows you how to create and apply filters.

30.1 Introduction to Filters

Your ZyWALL uses filters to decide whether to allow passage of a data packet and/or to make a call. There

are two types of filter applications: data filtering and call filtering. Filters are subdivided into device and

protocol filters, which are discussed later.

Data filtering screens the data to determine if the packet should be allowed to pass. Data filters are divided

into incoming and outgoing filters, depending on the direction of the packet relative to a port. Data filtering

can be applied on either the WAN side or the LAN side. Call filtering is used to determine if a packet should

be allowed to trigger a call. Remote node call filtering is only applicable when using PPPoE encapsulation.

Outgoing packets must undergo data filtering before they encounter call filtering as shown in the following

figure.

1 2 ... 432 433 434 435 436 437 438 439 440 441 442 ... 613 614

Komentáře k této Příručce

Žádné komentáře

Zyxel-communications Internet Security Gateway ZyWALL 2 Series Uživatelský manuál Strana 437

Komentáře k této Příručce

Související produkty a manuály pro Hardware Zyxel-communications Internet Security Gateway ZyWALL 2 Series