ZyXEL Communications ZyAIR Uživatelská příručka stáhnout pdf (Strana 131)

ZyAIR B-3000 User’s Guide

Chapter 15 SNMP Configuration 130

Figure 82 Menu 22 SNMP Configuration

Menu 22 - SNMP Configuration

SNMP:

Get Community= public

Set Community= public

Trusted Host= 0.0.0.0

Trap:

Community= public

Destination= 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

The following table describes the SNMP configuration parameters.

Table 45 Menu 22 SNMP Configuration

FIELD DESCRIPTION

SNMP:

Get Community Type the Get Community, which is the password for the incoming Get- and

GetNext requests from the management station.

Set Community Type the Set Community, which is the password for incoming Set requests from

the management station.

Trusted Host If you enter a trusted host, your ZyAIR will only respond to SNMP messages from

this address. A blank (default) field means your ZyAIR will respond to all SNMP

messages it receives, regardless of source.

Trap:

Community Type the trap community, which is the password sent with each trap to the SNMP

manager.

Destination Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

15.4 SNMP Traps

The ZyAIR will send traps to the SNMP manager when any one of the following events

occurs:

Table 46 SNMP Traps

TRAP # TRAP NAME DESCRIPTION

1 coldStart (defined in RFC-1215) A trap is sent after booting (power on).

2 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).

3 linkUp (defined in RFC-1215) A trap is sent when the port is up.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 220 221

Žádné komentáře

ZyXEL Communications ZyAIR Uživatelská příručka Strana 131