ZyXEL Communications STB-2101H Uživatelská příručka stáhnout pdf (Strana 15)

BeeSmart LITE Documentation

Please enter correct IP address for the BeeSmart LITE server when asked. Below is shown an example of the configuration settings:

Setting up the network:

=========================================================================

Please select the interface you want to configure:

0 ) eth0 < >

1 ) eth1 < >

interface: 0

=================================================================

Configuring interface eth0

I/F type ([A]dmin, [C]lient, [B]oth, [D]isable): b

IP address: 192.168.11.15

Netmask: 255.255.255.0

Default gateway: 192.168.11.22

Make default? [y/n] y

Please note that BeeSmart LITE comes with only one Ethernet port configured, combining management and client

network on the same Ethernet interface

After the installation is completed you will be prompted to restart the server.

After reboot you may proceed with server configuration:

Please make sure that you reboot the server after the SW packages installation is finished

BeeSmart LITE network configuration can be re-configured at any time by running the following command:

# /home/beesmart/scripts/

#./bs_config

#=======================================================#

# #

# BeeSmart configuration utility #

# #

#=======================================================#

# #

# Please enter your selection: #

# 1 ) Network configuration #

# 2 ) System Diagnostic #

# <CTRL+C> to exit #

# #

#=======================================================#

Run:

Choosing option 1 the utility lists all the available interfaces and their current configuration:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Žádné komentáře

ZyXEL Communications STB-2101H Uživatelská příručka Strana 15