ZyXEL Communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Uživatelská příručka Strana 262

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 519
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 261
Prestige 2602HW Series User’s Guide
262 Chapter 21 Maintenance
21.7 Firmware Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
"*.bin" extension, e.g., "Prestige.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See Chapter 37 on page 365 for upgrading firmware using FTP/TFTP commands.
Only use firmware for your device’s specific model. Refer to the label on the bottom of your
device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.
Figure 124 Firmware Upgrade
The following table describes the labels in this screen.
Note: Do not turn off the Prestige while firmware upload is in progress!
After you see the Firmware Upload in Process screen, wait two minutes before logging into
the Prestige again.
Table 84 Firmware Upgrade
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
Reset Click this button to clear all user-entered configuration information and return the
Prestige to its factory defaults. Refer to the Resetting the Prestige section.
Zobrazit stránku 261
1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 518 519

Komentáře k této Příručce

Žádné komentáře