Zyxel-communications ISDN Terminal Adapter Omni.Net Lite Uživatelský manuál stáhnout pdf (Strana 58)

Omni.Net Lite User’s Guide

57 Chapter 3 Using AT Commands

W2 Display user data.

W3 Display phone number of calling site and user data.

X Enable/Disable extended result code.

X0 Basic result code (default).

X1 Extended result code.

Z Reload user-defined profile.

&C DCD signal control.

&C0 Follow DTR signal.

&C1 ON only if in communication (default).

&D DTR (Data Terminal Ready) signal control.

&D0 Ignore DTR signal, assume DTR is always ON.

&D1 DTR OFF-ON transition causes dial of an outgoing call using the

first pre-stored phone number.

&D2 DTR OFF causes the modem to hang up (default).

&F Restore the factory default.

&K Set flow control mode.

&K0 Disable flow control.

&K3 Enable CTS/RTS flow control (default).

&K4 Enable XON/XOFF flow control.

&S DSR (Data Set Ready) signal control.

&S0 Follow DTR signal (default).

&S1 Follow DCD signal.

&V Display all data parameters settings.

&W Save current parameters setting, include &-leading and non-

leading parameters, as user defined profile.

%D0=n Select DTE baud rate when system is powered on.

n=8: 9600 bps

n=11: 19200 bps

n=13: 38400 bps

n=16: 57600 bps

n=17: 115200 bps (default)

n=21: 230400 bps

%D1=n Select DTE attribute when system is powered on.

n=0: 8 data bits, non parity (default)

n=1: 7 data bits, even parity

n=2: 7 data bits, odd parity

%D2=n Dial an outgoing data call automatically if there is pre-stored

dialing number after system is powered on.

n=0: do nothing (default)

n=1: auto-dial after power on

Table 14 AT Data Command Sets Requiring an "AT" Prefix

COMMAND OPTION DESCRIPTION

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 83 84

Komentáře k této Příručce

Žádné komentáře

Zyxel-communications ISDN Terminal Adapter Omni.Net Lite Uživatelský manuál Strana 58

Komentáře k této Příručce

Související produkty a manuály pro Hardware Zyxel-communications ISDN Terminal Adapter Omni.Net Lite