Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Uživatelský manuál stáhnout pdf (Strana 68)

100

101

P-793H User’s Guide

68 Chapter 4 Point-to-point Configuration

4.2 Point-to-point Connection Procedure

Follow these directions to set up a point-to-point connection.

1 Set up the Server.

2 Set up the Client.

3 Connect the ZyXEL Devices.

4.2.1 Set up the Server

1 Log in to the ZyXEL Device that will be the server. (See Chapter 2 on page 45.)

2 Click Network > WAN > Internet Connection.

3 Configure the VPI, VCI, Multiplexing, and Encapsulation fields for the point-to-point

connection. In the Encapsulation field, select either RFC 1483 or ENET ENCAP.

4 Scroll down to the Service Type section. The following screen appears.

Figure 21 WAN > Internet Connection > Service Type

5 In the Service Mode field, indicate whether the phone line is a 2-wire connection or a 4-

wire connection.

6 In the Service Type field, select Server. The rest of the fields are enabled.

7 Configure the rest of the fields, if necessary. For example, you might want to set the

Transfer Max Rate to the maximum value.

8 Click Apply.

4.2.2 Set up the Client

1 Log in to the ZyXEL Device that will be the client. (See Chapter 2 on page 45.)

2 Click Network > WAN > Internet Connection.

3 Set the VPI, VCI, Multiplexing, and Encapsulation to the same values you set in the

server.

4 Scroll down to the Service Type section. See Figure 21 on page 68 above.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 431 432

Komentáře k této Příručce

Žádné komentáře

Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Uživatelský manuál Strana 68

Komentáře k této Příručce

Související produkty a manuály pro Hardware Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H