ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Uživatelská příručka Strana 51

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 386
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 50
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
51
6.2 Interface General Commands Summary
The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
The following sections introduce commands that are supported by several types of interfaces.
See Section 6.6 on page 68 for the unique commands for each type of interface.
6.2.1 Basic Interface Properties and IP Address Commands
This table lists basic properties and IP address commands.
Table 15 Input Values for General Interface Commands
LABEL DESCRIPTION
interface_name The name of the interface.
Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N,
where N equals the highest numbered Ethernet interface for your ZyWALL model.
ZyWALL USG 100 and 200 models use a name such as wan1, wan2, opt,
lan1, ext-wlan, or dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the
virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge
interfaces your ZyWALL model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge
interface, y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of
PPPoE/PPTP interfaces your ZyWALL model supports.
profile_name The name of the DHCP pool. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
domain_name Fully-qualified domain name. You may up to 254 alphanumeric characters,
dashes (-), or periods (.), but the first character cannot be a period.
Table 16 interface General Commands: Basic Properties and IP Address Assignment
COMMAND DESCRIPTION
show interface {ethernet | vlan | bridge | ppp
| auxiliary} status
Displays the connection status of the specified type
of interfaces.
show interface {interface_name | ethernet |
vlan | bridge | ppp | virtual ethernet |
virtual vlan | virtual bridge | auxiliary |
all}
Displays information about the specified interface,
specified type of interfaces, or all interfaces. See
Section 6.6.1 on page 71 for all possible cellular
status description.
show interface send statistics interval Displays the interval for how often the ZyWALL
refreshes the sent packet statistics for the
interfaces.
show interface summary all Displays basic information about the interfaces.
show interface summary all status Displays the connection status of the interfaces.
[no] interface interface_name Creates the specified interface if necessary and
enters sub-command mode. The
no command
deletes the specified interface.
Zobrazit stránku 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 385 386

Komentáře k této Příručce

Žádné komentáře